| |
<<Todd,
The exhaust on your Corrado, is that the one from ND? We were talking
about that the other day at Adam's but I forget what you said when I
asked where the exhaust system started, was it cat-back? ...and not
to be tacky, but what is the cost of that system in total?
Thanks....
- -Eric
Oh yeah, here is a real general NON VR6 question, why do front wheel
drive cars still have a hump in the middle of the car? (guess I was
too lazy to take a look underneath)>>
Hey Eric,
I have the Techtonics exhaust, which is cat-back. It has two resonators and a
Borla rear muffler. There are two versions: we sell the aluminized one (with
stainless Borla) for $385, and the full stainless (which is what I have) for
$490. We charge $75 labor for installation. The Techtonics system comes
without a tip, and we bevel cut the tail pipe for asthetics, or you can add a
tip of your choice. Must have a 2.5" inlet. I have a G60 outer shell on my
tip.
The floorpan hump in a FWD car is for.... the exhaust!
Regards,
Todd
Air & Water
VW Tuning
Philadelphia
|
Thu Feb 26 13:15 CST 1998
